Webhadc1.Init.EOCSelection = ADC_EOC_SEQ_CONV; I also had to enable the overrun setting as well: hadc1.Init.Overrun = ADC_OVR_DATA_OVERWRITTEN; Without this the HAL_ADC_PollForConversion was still blocking. I do not fully understand why this was necessary but it does allow me to poll in continuous mode. Hm... WebMar 15, 2024 · I'm trying to sample a 1MHz signal with the DMA method. The settings that I use for ADC: -Synchronous clock mode by 1 (72 MHz) -12 Bits. -Continuous Conversion is enabled. -Sampling Time 19.5. The sampling rate is …
Dual ADC mode single DMA configuration. There is no …
Webhadc.Init.Overrun = ADC_OVR_DATA_OVERWRITTEN; if (HAL_ADC_Init(&hadc) != HAL_OK) { Error_Handler(); } /** Configure for the selected ADC regular channel to be converted. */ sConfig.Channel = ADC_CHANNEL_13; sConfig.Rank = ADC_RANK_CHANNEL_NUMBER; sConfig.SamplingTime = … WebOct 26, 2024 · Any ADC has non-linearities and datasheets provide often the inaccuracy, e.g. how many bits are not reliable. It can be up to 2 bits per sample. A good (external) ADC reference can improve the accuracy, but you cannot overcome the ADC internal inaccuracy. how do you connect corrugated pipe
STM32 ADC conversion using HAL - maquleza.afphila.com
Webhadc->Init.Overrun = ADC_OVR_DATA_OVERWRITTEN; hadc->Init.LeftBitShift = ADC_LEFTBITSHIFT_NONE; hadc->Init.ConversionDataManagement = ADC_CONVERSIONDATA_DMA_CIRCULAR; hadc->Init.LowPowerAutoWait = DISABLE; hadc->Init.ContinuousConvMode = DISABLE; hadc->Init.DMAContinuousRequests = … WebFeb 24, 2024 · The ADC conversion sequence can be started by a timer event as well. In this case, continuous conversion mode should be disabled, and an event source must be selected in the EXTEN and EXTSEL bits of the ADC->CFGR register. Webhadc1.Init.Overrun = ADC_OVR_DATA_OVERWRITTEN; if (HAL_ADC_Init (&hadc1) != HAL_OK) { Error_Handler (); } /** Configure the ADC multi-mode */ multimode.Mode = ADC_MODE_INDEPENDENT; if (HAL_ADCEx_MultiModeConfigChannel (&hadc1, &multimode) != HAL_OK) { Error_Handler (); } /** Configure Regular Channel */ … how do you connect controller to pc